User guide

iGuard/inSight User Guide
Release 7.0.0.4
149
3. Select the filter you want to activate.
4. Verify that the filter has been added to the bottom of the list of active filters.
5. If it is a network filter, reprioritize to run it in the correct order.
Deploy Capture Filters
If you are on a standalone iGuard, when you create a capture filter you can either deploy the filters
on your own machine, or check "None" to indicate that you want to deploy it later. If you want to
wait and deploy it later, just modify the filter at that time.
Use the same method to deploy a different set of capture filters from inSight to each iGuard. After
deployment is complete, each iGuard is listed along with the list of filters deployed on each.
1. Go to System Administration > Capture Filters.
2. Pull down the Views menu and select the Content or Network Filters list.
3. Click on the filter you want to install. It may be a default filter, or it may be a new one
that you have recently added.
4. In the deployment dialog box, check the device on which you want to install the capture
filter.
5. Select Save.
A message will alert you to whether or not the modification was successful.
If so, the filters list that is launched shows that the filter has been modified.
View Deployed Capture Filters
You can find out which filters are deployed on each iGuard on your network.
1. Go to System > System Administration > Capture Filters.
2. Each iGuard listed displays two types of capture filters.
3. If you are on an insight Console, you can scroll down the list to get complete
information on your managed systems.
Each iGuard listed displays two types of capture filters.
If you are on a standalone iGuard, you will see only the filters deployed on your own machine.
Note: If you are viewing one of the multiple iGuards lists, you can get back to this window by
pulling down the View menu and selecting Filter By iGuard.