User guide

Reconnex Corporation
148
Release 7.0.0.4
Filters that define larger amounts of traffic should be placed at or near the top of the list.
For example, if you added a filter to ignore all traffic to and from ports 80 and 453, you would be
ignoring all HTTP and HTTPS traffic. In such a case, you would not need individual filters like
Ignore HTTP Responses or Ignore HTTP Requests.
1. Add a new network capture filter - in this case, a port filter.
2. Use the UP arrow in the Priority column to move it up to the correct position.
3. Apply.
Tip: Move the new filter up until it is in a position to filter out more traffic than the filters below
it, but less than those above it.
Activate a Capture Filter
A capture filter can be added to an iGuard without being deployed. If "None" is selected when the
filter is created or modified, it is not deployed, but it is available for activation.
1. Go to System > System Administration > Capture Filters.
2. Select the Add Filter icon at the bottom of the network or content capture filter list.
A list showing the available filters is launched.