User guide

Reconnex Corporation
130
Release 7.0.0.4
2. Select the Detail link opposite your username in the navigation bar.
3. Note your Current Group Membership.
4. Go to System > User Administration > Groups.
5. Select the Detail link opposite your user group(s) in the navigation bar.
6. Select the Task or Policy Permissions tab.
7. Expand the lists of resources by clicking on the drop-down arrow.
8. Note the boxes checked indicating the privileges allocated to your group(s).
Note: Administrator status is required to set permissions for groups.
Primary Administrator
The primary administrator has complete access to all task and policy permissions and essentially
owns the inSight Console.
If you need primary administrator login information, contact Reconnex Technical Support.
As primary administrator, you may want to share administrative duties by creating additional
administrators. To do this, create new groups (e.g., administrative sub-groups like system or
network administrators) to allow specialization in those areas, then create user accounts for those
administrators and assign them to the appropriate groups.
Tip: If you are the primary administrator, you should create an equivalent user immediately
after logging in to preserve the integrity of the default login. You should also consider setting
up a failover account.
Audit Logs
User audit logs on the inSight Console make it possible to monitor all user activity on any of the
iGuard systems. iGuard standalone systems also have user audit logs, but they log activity on that
iGuard only.
Each of the columns in the log can be sorted by clicking the header, and the log itself can be
filtered to find the most pertinent results.
Audit Log Actions
The User Audit Log page gives specific information on the actions each user executes on the
iGuard and records the date and time each action was taken. Further, each login session is
preserved and identified.