User guide

iGuard/inSight User Guide
Release 7.0.0.4
129
Create a Failover Account
If the link between the inSight Console and its iGuards is broken, the default failover account can
be used to login to the iGuards.
Note: The failover account is enabled by default for your convenience. If you do not want to
have backdoor access from inSight to your iGuards, you can disable it by disallowing logins.
If logins are not allowed and a login attempt is made, an error message will be launched
advising that the capability has been turned off.
1. Go to System > User Administration > Failover Account.
2. In the User Information dialog box, provide a username and password for the
account.
The username and password for this account are the same as that of the primary
administrator. If you want to allow login to this account, it is advisable to change the password.
3. If you want to turn the account off to tighten security on your iGuards, pull down the
Allow Login menu and select Off.
4. Update.
Find Permissions
All of your permissions are inherited from your group affiliation, so you must know what group you
are in to find out what they are.
Note: If your permissions have been changed, you must re-login for the change to register. It
doesn't matter if you're an LDAP or local user.
1. Go to System > User Administration > Users.