Installation Instructions

7
The following figures show the hardware installations at both the base station side and the
client station side to allow the client side networking devices to connect to the Internet through the TV
whitespace link between the base station and the client station.
ACRS 2.0
Base Radio
Feed Cable
Antenna
Ethernet Switch
Ethernet
Internet
Ethernet
Base Control
PC
Base station installation diagram.
ACRS 2.0
Client Radio
Feed Cable
Antenna
Ethernet Switch
Ethernet
Broadband
Router
Ethernet
Ethernet/WiFi
Client
Devices
Client Control
PC
Client station installation diagram.
For both the base station and the client station installations, the ACRS 2.0 radio SMA connector
is connected to the feed cable which is connected to the antenna. The base and client radio operation
can be controlled through base control PC or client control PC connected to the radios through Ethernet
switches.
Once the hardware installation is complete, follow the instructions in the following sections to
perform the software installation on the control PC. Note if an installed radio unit is redeployed at a
differently location, the installer must reconfigure the radio coordinates to reflect the location
change.