Installation Instructions

13
4) Go to the “Installation” pane and enter the correct output attenuation level as discussed in
Section “Hardware Installation”. The installation pane also allows the installer to set the static IP
address for the base. Please enter the desired IP address, subnet mask and gateway as shown
below.
5) Click “Save All Settings to Target And Reboot” button shown above. This will save all the
installation information including device registration information, channel list information,
output attenuation level, base IP address, etc. to the base internal configuration flash. The
software will prompt the user to restart as shown below. Click “OK”. The next time the software
will launch in the “User” mode where all the installation options will be loaded directly from
device flash and cannot be altered.
6) Restart the software and it should launch in the “User” mode as shown in the following figures
where the installation options are loaded from device flash.