User's Manual

9
.
Base Station Operation
The base station operation is discussed in the following.
1) When the software launches on the base control PC, it will automatically contacted the
database and the available channels are shown after “BASE MAC…”. The prompt “Select From
Available Channels” requests the user to select a valid channel from the channel list. Note
further that device registration is not performed in the “User” mode but during installation – see
“ACRS 1.0 Professional Installer Manual”.
2) Select a channel from the pull down menu on the prompt and click “Select” to set the base
operating channel as shown in the following.
3) After the channel selection, the link pane is shown as following. Click “Start Service” to start
transmission on the base station.