Installation Instructions

15
Client Station Setup
The following steps should be followed on the client station to complete the installation.
1) Launch the “AdaptrumTVBD” software in the “Start/AdaptrumClient/Adaptrum”. The software
will start in “Installer” mode where the installer can enter client registration information on the
“Database” pane as shown in the following figure. Note that only device information and
location information is set from the client side. Other database registration information, e.g.
contact information, is set from the base side.
2) On the “Database” pane, enter the scan channel set using the “…” button right next to “Scan
Channel Set”. When “…” button is clicked, the scan channel selection window will pop up. Select
the desired channels and then click “Update Now” to update the scan channel set.