Installation Instructions

14
Client Station Setup
The following steps should be followed on the client station to complete the installation. Note
that the following steps require an active connection to the base station.
1) Launch the “Adaptrum” software in the “Start/AdaptrumClient/Adaptrum”. The software will
start in “Installer” mode where the installer can enter client registration information. Note that
only location information is set from the client side; all other registration information, e.g.
contact information, is stored on the base station.
2) Go to the “Database” pane and enter the scan channel set using the “…” button right next to
“Scan Channel Set” as shown in the following figure. When “…” button is clicked, the scan
channel selection window will pop up. Select the desired channels and then click “Update Now”
to update the scan channel set.