Installation Instructions

11
Post-Installation Setup
The installer needs to perform the following steps to complete the system installation.
Base Station Setup
On the base station control PC:
1) Launch the “Adaptrum” software in “Start/AdaptrumStation/Adaptrum”. The software will start
in the “Installer” mode where the installer can enter registration information and channel list
request.
2) As shown in the following figure, enter the correct registration information and click “Register
Device” on the “Database” pane to register device. Then enter the correct channel list
information and click “Reset Channel List” to request a channel list. Note that the system starts
in an undefined channel, the software will prompt the installer for channel selection. Note that
the version of software shipped with the installation kit works with Google TV Whitespace
Database. For more information about Google TV White Space Database, please visit
http://www.google.org/spectrum/whitespace/
.
3) Go to the “Installation” pane and enter the correct output attenuation level as discussed in
Section “Hardware Installation”.