Car Speaker User Manual

17
Setting a sign’s TCP/IP address
Before you can begin to use an AlphaPremiere™ sign on a Ethernet network, the display must be assigned
a unique TCP/IP address.
NOTE: The Alpha® Ethernet option inside the display is shipped with a default address of 010.11.11.1.
To set a new IP address, follow these steps:
1. Get a unique IP address from your network administrator. An example of an IP address is: 10.67.12.21.
2. Write down the 6-digit Ethernet address found on the Ethernet option label the back of your sign. For
example, the Ethernet address for the following label is: 00-20-4A-54-09-C8.
3. Using the Configuration Utility software supplied with the sign, select Tools > Assign IP . . . :
4. Next, select Tools > Ping Device . . ., enter the sign’s IP address, and click on Ping to make certain that
the IP address you just assigned works.
Ethernet address
2
32/A
U
X
R
XD
T
X
D
RS
2
3
2
/
A
U
X
R
S
4
8
5
4
2
S
p
k
r
O
u
t
S
i
g
n
R
e
s
e
t
RS4
8
5
6
This label is
on the back
of Ethernet-
equipped
signs.
Enter the IP address from step 1.
Enter the Ethernet Address from step 2.
Click Set IP Address.
If a reply from the sign is not received, try assigning
the address again by repeating the previous steps.