Installation guide

Theater Installation Guide (97127016B) 43
Software and Installation Verification — Verifying the installation
Verifying the installation
Verifying house sign addresses
When the house signs first boot up, they will display their hex address. Verify this is correct based on the
house number. Refer to “About addressing signs” on page 15 for more information.
Rebooting the displays
These instructions apply to Box Office, directional, and outdoor signs because these signs must be reset in
order to configure the memory and establish communications. This is done through the Simply Theatre
Software.
To reboot Box Office, directional, and outdoor signs:
1. Open the appropriate emulator and click the e.
Figure 25: Opening the Box Office emulator.
Select the appropriate
emulator (the Box
Office emulator is
shown as an example).