Instruction manual

11
- Battery may be too low.
- The mic is very sensitive and might pick up electrical noise
such as air conditioners, electric motors, power lines, etc.
- Some older models have a Short Play / Long Play (SP/LP)
mode. Make sure the device is in Short Play mode.
A mechanical sound is heard at the end of a message.
- Record using an external switch such as an Adaptivation Pal
Pad or any other switch with no moving parts.
Messages are garbled on mid or high volumes, but the sound
is good on very low volume.
- Replace the battery with a fresh battery.
No power-up beep, or poor sound.
- Battery may be dead or too weak. Remove battery, wait 2
minutes and try again. If there is no beep, replace the bat-
tery with a fresh battery.