Instructions

Short Instructions
for Oil Service Reset OBD 2 for
BMW/Mini/Rover
Adapter-Universe is a brand of
Tradefox GmbH, www.tradefox.de
Leonhardsweg 2, 82008 Unterhaching
Germany, [e-mail]
Important instructions! Read the operating instructions completely and carefully. It is an integral part of the product
and contains important notes on the use. Keep this document for future reference.
Use
Fits BMW, Mini and Rover 75 from date built 2001 with OBD-2 diagnostic connection.
The service reset device is connected to the OBD-2 diagnostic connector.
(In the vehicle interior, usually below the dashboard on the left)
1.Connect the device to the OBD-2 connector of your vehicle
2.All the LEDs flash first and then light up constantly
3.Turn the ignition key (do not start the engine!)
4.Press the button for the desired function
5.All the LEDs light up to show the successful reset
The following ads can be returned:
1. Oil service
2. Inspection
3. Annual maintenance (clock symbol)
Please note:
For some combination instruments, the oil service must be reset before an inspection
reset.
Warranty and liability
Since the manufacturer has no influence on the installation of the product, the warranty
covers only the product itself. The manufacturer is not liable for personal injury or property
damage caused by improper maintenance, operation or installation. Improper handling of
the instructions described in this manual is also inappropriate. Do not modify the product
or its accessories. Any application areas different than those described in this manual are
prohibited and result in loss of warranty and non-liability. We reserve the right expressly to
make changes and printing errors to the packaging, instructions and equipment.
Disposal instructions
Electrical and electronic equipment must not be disposed with the household
waste according to the European WEEE Directive. Their components must
be separately recycled or disposed because toxic and hazardous compo-
nents can damage the environment in the event of improper disposal.
As a consumer under the ElektroG, you are obliged to return electrical and
electronic equipment at the end of its service life.
Details of this are governed by the respective national law.
The symbol on the product, the operating instructions and/or the packaging
indicate these requirements. With this type of material separation, recycling
and disposal of old equipment, you make an important contribution to the
protection of our environment.
WEEE Directive 2012/19/EU WEEE-Reg.-No.: DE 83960128
Technical specifications
Manufacturer number
7140
Input voltage
12 V
Cable length
About 30 cm
Note: We reserve the right to do technical changes.
No part of this work may be reproduced, modified, distributed, or otherwise used without
written permission.