User's Manual

7
 L'installateur doit prévoir un système de sauvegarde en cas de chute de la vidéo.
 Cet équipement ne doit pas être réparé ou entretenu pendant son utilisation avec le
patient.
 ATTENTION : Pour éviter le risque de choc électrique, cet équipement doit être raccordé
à un réseau électrique protégé par une mise à la terre.
 La fiche est utilisée pour la déconnexion du réseau électrique, ne placez pas
l'ÉQUIPEMENT ME de telle sorte qu'il soit difficile d'utiliser le dispositif de déconnexion.
 Faites appel à un personnel qualifié pour le remplacement de pièces ou la vérification de
l'appareil.
Installation
● Place the equipment on a flat, solid and stable surface. Do not used on the floor.
If you use an unstable cart or stand, the equipment may fall, causing serious injury to a
child or adult, and serious damage to the equipment.
● Do not allow to climb, rest, sitting or stepping on the equipment.
● When adjusting the angle of the equipment, move it slowly so as to prevent the equipment
from moving or slipping off from its stand or arm.
● When the equipment is attached to an arm, do not use the equipment as a handle or grip
in order to move the equipment. Please refer to the instruction manual of the arm for
instructions on how to move the arm with the equipment.
● Provide full attention to safety during installation, periodic maintenance and examination of
this equipment.
● Sufficient expertise is required for installing this equipment, especially to determine the
strength of the wall for withstanding the display’s weight.
● Do not cover or block any ventilation openings in the cover of the set. When installing the
device in a cupboard or another closed location, heed the necessary space between the
set and the sides of the cupboard.
● Power on after rear cover installed while remove the rear cover after power off.
● The display panel, standard attached to a stand, is compatible with the VESA 100 mm
standard.
1). Put the display face down on a clean and soft surface. Be careful not to damage the
panel screen.
2). Unscrew the four fixation screws to detach the panel from the stand.
3). Use 4 M4 screws to attach the panel to a VESA approved arm