User`s guide

Configuring Your Wireless Router

Adjusting the WAN Settings

You must adjust the WAN settings on your Wireless Router to work

with your Internet Service Provider (ISP) account.

Note: See Before You Begin... on page 9 for a list of information

you’ll need to successfully adjust the WAN settings. Refer to

your ISP for additional information, if required.

To adjust the WAN settings:

1 Open the Utility and log in. (See page 22.)

2 Click WAN under Basic Setup on the menu list.

3 Select your WAN Connection Type, then follow the on-screen

instructions to fill in the connection information. (Some

information fields may be filled in automatically by the Utility,

based on data provided by your ISP.)

4 PPPoE users only—Enable Dial on Demand if you want your

Wireless Router to attempt to connect with your ISP when there

is at least one network user wanting to access the Internet and

there is no current WAN connection.

Enable Auto-disconnect if you want your Wireless Router to

disconnect automatically when your Internet connection is idle

for longer than the specified time (in seconds).

5 Click Save & Restart.

Note: You can choose a different connection type at any time as

your networking requirements change.

The information fields that

appear depend on which

WAN Connection Type you

select.