User`s guide

Mounting a Snapshot Set
When you create a snapshot set, you have the option to mount it to a specific system
on your IP SAN. (The individual snapshots within a snapshot set are either all
mounted or all unmounted. You can’t mount just some individual snapshots.) If
you choose not to mount a snapshot set during creation, you can mount it after it
has been created.
To mount a snapshot set:
1 In the Enterprise View, select the iSCSI Storage Host you want.
2 In the Snapshots View, select the title of the snapshot set.
3 Click the Mount Snapshots button (shown at right). Or, In the Actions menu,
select
Mount snapshot set.
The Mount Snapshot Set window opens.
4 Select the iSCSI Storage Host on which to mount the snapshots.
5 Set a mount point for the snapshots of each volume by selecting a drive letter or
entering the full path to an empty directory.
Each snapshot must have its own mount point.
6 Set the access type (Read only or Read/Write).
All snapshots in the snapshot set will have the same access type.
7 Click OK to mount the snapshot set.
Caution If you set up a recurring job that creates and mounts a snapshot on the
same disk drive, you must free the disk drive after each job or the job will fail.
Deleting a Snapshot Set
Although you can’t delete an individual snapshot, you can delete an entire
snapshot set.
To delete a snapshot set:
1 In the Snapshots View, select the title of the snapshot set.
2 Click the Delete Snapshots button (shown at right). Or, In the Actions menu,
select
Delete snapshot set.
3 Click Yes to delete the snapshot set.
Snapshot set title (text)