User`s guide

The CLI Setup wizard then prompts you to enter the values you prepared in
“Before You Begin” on page 34.
Note Adaptec highly recommends that you record the values you enter during
this task and store them for future reference.
2 At the Hostname prompt, type a name for the iSCSI Storage Appliance, then
press
Enter. Use alphanumeric characters, such as Hostname or Hostname1.
3 Type the network domain to which the iSCSI Storage Appliance belongs, then
press
Enter. Use alphanumeric characters, such as Domain or Domain1.
4 Press Enter to accept the current system date, or type a new date, then press Enter.
Use this format:
[hh:mm:ss@mm/dd/yy]
5
Press Enter to accept the current time zone, or type a new time zone, then press
Enter. Use this format: GMT+12 – GMT-12
6
Type yes (the whole word, not just “y”) to create a new administrative password,
then press
Enter. Type the new password, then press Enter Confirm the new
password, then press
Enter.
7 Type a new operator password, then press Enter. Confirm the new password,
then press
Enter.
8 Press Enter to accept the DHCP default setting (No).
9 Press Enter, or type a default gateway address (the name or IP number of a router
to which packets for destinations that do not have routes defined for them in the
system should be sent), then press
Enter.
10 Press Enter, or type the IP addresses of your DNS servers (up to three are
supported), then press
Enter.
11 Type the IP address for the iSCSI Storage Appliance, then press Enter.
Use this format:
xxx.yyy.zzz.aaa
12
Type the netmask of the iSCSI Storage Appliance, then press Enter.
Use this format:
xxx.yyy.zzz.aaa
13
Type the IP address to be used for broadcasts, then press Enter.
Use this format:
xxx.yyy.zzz.aaa
14
When the configuration is complete, the host name given to the iSCSI Storage
Appliance displays (for example, myhostname#).
15 Type quit, then press Enter to log out of the CLI.
16 Disconnect from the iSCSI Storage Appliance.
Caution To avoid permanent data loss, do not modify the default BIOS settings of
the RAID controller. To safely configure or modify the iSCSI Storage Appliance, use
either the CLI or Adaptec Storage Manager only.