User`s guide

Access Levels and Passwords
The CLI has two levels of access: operator or administrator. The default password
for both levels is
admin.
Operator-Level Access
From the operator level, you can monitor the current status of the iSCSI Storage
Appliance, but you cannot make any configuration changes.
To set the operator password, type:
password operator <Enter>
new password ***** <Enter>
confirm new password ***** <Enter>
Note You must be in Administrator level to set passwords.
Administrator-Level Access
From the administrator level, you have full access to all the features of the software
and can make changes to the configuration of the iSCSI Storage Appliance.
Note The default administrator password is
admin.
To change the administrator password type:
password administrator <Enter>
new password ***** <Enter>
confirm new password ***** <Enter>
Switching Access Levels
To switch from operator level to administrator level, type administrator, press Enter,
type the administrator password, then press
Enter.
To switch from administrator level to operator level, type operator.
Note If you forget a password, you can log into the iSCSI Storage Appliance by
connecting a serial cable to the COM 1 port of the iSCSI Storage Appliance and
using a terminal emulation program, such as Hyperterminal. (For terminal
emulation program settings, see page 179.) You are not required to enter a
password. Set up new passwords by following the instructions in “Operator-Level
Access” or “Administrator-Level Access” on this page.