User`s guide

3 Log in to the CLI as Administrator, using the password you set in “Step 2:
Configuring the iSCSI Storage Appliance” on page 36. If you didn’t set a
password, use the default password,
admin.
4 Enter:
isns
5 Enter:
server IP_address
Where IP_address is the address of the iSNS server (see Step 1).
6 To exit the CLI, enter:
end
quit
Note For more information about the CLI, see “Using the CLI” on page 179.
7 Configure iSNS in the iSCSI initiator.
You will need to configure the initiator and add an iSNS server to complete the
configuration of iSNS.
For example, from a Windows client:
• When using the Microsoft initiator, run the Microsoft initiator software, select
the iSNS Servers tab, and click
Add. Enter the name or address of the iSNS
server, and then click
OK.
• When using the QLogic4050/4052 initiator, right-click the QLogic adapter and
select
Properties. Select the Discovery Configuration tab, and check Perform
Discovery
. Check Use iSNS Server, enter the server name or IP Address, and
click
OK.
Note After you have completed this procedure, all the iSCSI targets on the iSCSI
Storage Appliance automatically appear in the Microsoft Initiators target list.