User`s guide

4 Continue adding user names and passwords until all users are included on the
list.
Note The user list must have at least one name on it.
5 Click Cancel to close the window.
6 Repeat Step 2 to 5 for each logical device with CHAP authentication.
7 Click Next, then click Next again.
8 Click Apply, then click Yes.
Removing iSCSI Targets and Adding the Appliance IP Address
1 On the iSCSI Storage Host, go to the Start menu and open Microsoft iSCSI
Initiator
.
The iSCSI Initiator Properties window opens.
2 Click the Targets tab, then log off any iSCSI target whose status is ‘Reconnecting’.
3 Click the Persistent Targets tab, then remove any iSCSI target whose status is
‘Inactive’.
4 Click the Discovery tab.
5 From the list of IP addresses, remove any address that does not belong to the
iSCSI Storage Appliance.
6 Click Add.
7 Enter the IP address for the iSCSI data port on your iSCSI Storage Appliance (as
set in “Step 2: Configuring the iSCSI Storage Appliance” on page 36), then click
OK.
If your iSCSI Storage Appliance has two iSCSI data ports, repeat this step for the
other port.
Logging into the iSCSI Targets
1 In the iSCSI Initiator Properties program, click the Targets tab.
2 Select an iSCSI target, then click Log On....
3 Select Automatically restore this connection....
If CHAP is enabled on this iSCSI target, click
Advanced, select CHAP logon
information
, enter the user name and password (‘target secret’) for that iSCSI
target, then click
OK.
Note The target secret is the password you set in “Removing iSCSI Targets and
Adding the Appliance IP Address” on page 157.
4 Click OK to log on to the iSCSI target.