User`s guide

Sending a Test Message
To ensure that an email recipient is receiving event notifications, you can send them
a test message.
To send a test message:
1 In the Enterprise View, select the Management Service you want.
2 Click the Configure button, select the Management Service, then select Email
Notifications.
3 Select the email address.
4 In the Actions menu, select Send test message.
The test message is sent. If the test is successful, the email recipient receives the
test message. If the test fails:
a Ensure that the recipient’s email address is correct.
b Ensure that your SMTP server address is correct.
c Try sending the test message again.
Modifying a Recipient’s Information or Removing a Recipient
This section describes how to modify a recipient’s email address, change the types
of event notifications that are sent, or stop sending email notifications.
To modify a recipient’s information:
1 In the Enterprise View, select the Management Service you want.
2 Click the Configure button, select the Management Service, then select Email
Notifications.
3 Select the email address.
4 Modify the recipient’s information as required, then click OK.
Or,
In the tool bar, click
Delete email recipient, then click Yes to confirm the deletion.
Modifications become effective immediately. If you have deleted an email recipient
but you still want to be notified about status and activity by email, set up a new
email recipient following the steps in “Setting Up Email Notifications” on page 127.