User`s guide

Controller LEDs
The controller has two LEDs that indicate status.
These LEDs operate as described in the following table:
Notifying Users By Email About Status and Activity
You can set up Adaptec Storage Manager to send email messages (or notifications) to
a selected email address when an event, such as the creation of a pool or the failure
of a disk drive, occurs on the iSCSI Storage Appliance. Email notifications also help
you monitor these activities on your IP SAN from any location:
• Progress of scheduled jobs, such as snapshot creation
• Changes in the status of the physical components of your IP SAN, such as disk drives
• Changes to the iSCSI Storage Appliance, such as the expansion of a volume, the
creation of a mirrored volume, or the creation of a hot spare
Only the email address you specify receives email notifications (see page 128). You
can specify which types of events generate email messages to ensure that urgent
issues receive immediate attention.
Follow the instructions in this section to:
• Set up email notifications (see page 127).
• Send a test email (see page 128).
• Modify a recipient’s information or remove a recipient (see page 128).
• Modify email settings (see page 129).
• Disable email notifications (see page 129).
LED Condition Indication
Master On Controller is current Master for enclosure.
Fault On 5-10 seconds only Enclosure is powering on.
On continuously Fault condition exists on controller
FAULT !
SEP MASTER
HOST
EXP
Fault LED (yellow)
Master LED (green)