User`s guide

4 To check that the image you selected will be used after the iSCSI Storage
Appliance is restarted, select the controller in the Physical Devices View, then in
the
Actionsmenu, select Select controller image.
In the example above, Image 2 is still the current controller image but Image 1 is
set to be the image the controller will use when you restart iSCSI Storage
Appliance.
5 Click OK.
Caution Do not make any configuration changes before you restart the appliance.
Any changes that you make will be lost when the appliance restarts.
6 Restart the iSCSI Storage Appliance (see page 110).
To check that the image you selected is running, select the iSCSI Storage
Appliance in the Enterprise View, select the controller in the Physical Devices
View, then in the
Actionsmenu, select Select controller image. The Current Image
should be the image you selected.
Image 1 will run when restarting
Image 2 currently running
Image 1 is currently running and
will also run the next time the
iSCSI Storage Appliance is
restarted.