User`s guide

3 Select a UPS connection type.
•If you select
SNMP, enter the SNMP host name or TCP/IP address in the UPS
SNMP Name field.
•If you select
Local USB, click Add.
In the Add Remote USB Enclosure window, enter the name or IP address of a
remote iSCSI Storage Appliance to which the local system will communicate
UPS information, then click
Add.
Repeat this step until you have added all the iSCSI Storage Appliances you
want to communicate with the local USB connection.
Note To remove an iSCSI Storage Appliance from the list, select it, then click
Remove.
•If you select
Remote USB, enter the local USB host name or TCP/IP address in
the USB Connected Enclosure field.
4 In the Enclosure Powered Off box, set the battery life threshold at which the iSCSI
Storage Appliance powers itself down. (The default is two minutes.)
5 Click OK.
Repeat the steps in this section for each iSCSI Storage Appliance in your IP SAN.