User`s guide

10-8

Fast Ethernet Network Interface Cards

Select a Failover Pair or standalone port and press Enter.

Select the protocol to assign to the current pair or port and

press Enter. (IPX and IP are the only protocols supported at

this time)

A list of frame types is displayed.

Note:

The IPX protocol supports all four frame types

and multiple frame types simultaneously. IP supports

either Ethernet_II or Ethernet_SNAP, but never both at

the same time.

If configuring IPX, set a unique IPX Network Number for each

frame type and press Enter.

If configuring IP, set a unique IP address number and IP subnet

mask from the IP parameters menu. Press Enter to complete

the changes.

Perform Steps 2 - 5 for each pair or port you want to configure.

Disabling IP or IPX Protocols

IP or IPX protocols can be disabled by deleting the IPX network

numbers or the IP address for each frame type.

Note:

You must delete all frame types for IPX if more than

one was used.