User`s guide

10-6
Fast Ethernet Network Interface Cards
2
Add a Failover Pair by pressing Ins. The program
automatically assigns a default pair name. If previous pairs
have been assigned, the new one is placed last in the list. The
default naming convention is as follows: the first pair is
assigned to Pair1, the next to Pair2, then Pair3, and so on.
3
Set Failover Pair Name— To assign a unique name to the
group, select Set Failover Pair Name from the Failover
Configuration menu and press Enter.
Type the group name and press Enter. The new name appears
at the upper right portion of the screen.
4
Add/Remove Ports— Add ports to a Failover Pair by selecting
the Add/Remove Ports option from the Failover Pair
Configuration menu and pressing Enter. You can add only two
ports to a failover pair.
If the Failover Pair is new, the Existing Ports dialog box will
show No Ports Present. To add ports to a pair, press INS.
Select ports from the Available Port(s) dialog and press Enter.
As ports are selected, they will appear in the Existing Ports
dialog box. The first port selected is the primary port for the
pair. To set one of the selected ports as the primary port, select
it from the Existing Ports dialog box, and press Enter.
When all ports have been selected, press Esc to complete the
change.
Duralink Failover Setup V2.1
< F1> Help
©
Netware Loadable Module
Failover Pair Name
<INS> to Add, <DEL> to Remove, <ENTER> to Configure,
<ESC> to go back to the previous menu.
Copyright 1998, Adaptec Inc.
< F10> Abort Setup
1
Pair1
Pair1
List of Existing Pairs
Set Failover Pairs
List of Existing
Add/Remove Ports
Set Failover Pair Name
Display Existing Ports