User`s guide

10-2
Fast Ethernet Network Interface Cards
Removing Previously Configured Drivers
If you have installed Duralink or Adaptec Ethernet drivers prior to
this installation, complete this section. This is to ensure that no
conflicts exist between previously installed drivers and Duralink
Failover. Do not install Duralink Failover 3.0 over 2.0.
1
Remove all load and bind commands related to EMPCI,
failover.ncf , fover.ncf or loadbal.ncf from the autoexec.ncf .
Caution:
Be sure to remove only these commands.
Errors may result in problems with other programs or
system components!
2
At the server prompt, type load inetcfg and press Enter.
3
Select Boards and press Enter.
4
Delete all existing EMPCI boards by selecting each and
pressing DEL.
5
Press ESC to exit inetcfg .
Fresh NetWare Installation
If you are loading NetWare on a new server, do not add a
LAN/Ethernet adapter when prompted in the NetWare setup
procedures. When prompted to add a LAN adapter, select No and
continue with the NetWare installation. Then proceed to the
following section.
!