User`s guide

10-1
10
▼▼▼▼
Installing Duralink Drivers
for NetWare
This chapter describes how to install the Duralink Failover utility on
a server running NetWare 4.1x/3.1x. Instructions in this section
cover both initial installation from the
fosetup.nlm
file contained on
the Duralink Installation Diskette, as well as instructions on
changing the configuration using the
foconfig.nlm
utility (residing
on the server after installation). Use foconfig or fosetup to install or
configure Duralink Failover. Otherwise, fostatus may not show the
proper configuration.
Installation Overview
The following procedures are covered in this chapter
■
Removing Previously Configured Drivers
on page 10-2
■
Initial Installation and Configuration of Duralink Failover
on
page 10-3
■
Viewing System Status Using fostatus.nlm
on page 10-10
■
Network Client Setup
on page 10-12
■
Reconfiguring Using foconfig.nlm
on page 10-12
Installation, configuration, and optional parameters for the Duralink
Failover utility are updated regularly. The
readme
subdirectory
contains supplemental installation instructions, as well as
information about optional keywords.