User`s guide

9-5
Installing Duralink Drivers for Windows NT
Configuring Ports
Note:
The following screen appears when first installing
Adaptec NICs.
1
From the Adaptec New Hardware Found dialog box, select the
port to configure from the New Adaptec Ports Available list
box.
2
Choose the appropriate connection type for your network.
Autodetect Default Connection is the recommended choice.
For an explanation of possible options see Connection Types on
page A-2.
Note:
The BNC connector is not supported by
Duralink Failover.
3
Click OK.
4
Repeat Steps 1 - 3 for each port.