User`s guide

7-3
IBM OS/2
– Enable one or more of the listed Ethernet frame types by
specifying YES in the appropriate boxes. (If you are not sure
which frame type(s) are used on your NetWare network,
enable all of them).
– Change the Network NIC Address to the Ethernet address
of your Adaptec NIC. This address must be different for
each port.
You can run
emdiag.exe from your Adaptec driver diskette
at an OS/2 command line prompt, and select Configuration
Status, to display your NIC's Ethernet address.
2
Repeat Step 1 for each port or for binding multiple protocols to
one port.
3
In the LAPS dialog box, select Close.
4
In the Multi-Protocol Transport Services dialog box, select Exit.
5
Select Update CONFIG.SYS and then select Exit.
6
If using Warp Connect or LAN Server software you must
reestablish the dependency path between the NetBios protocol
and the IBM software each time the NetBios protocol is
reconfigured. To do this, run the Install program and progress
through all of the online prompts.
7
If using the TCP/IP protocol go to the command line prompt
and type tcpcfg. Progress through the online prompts.
8
Shut down OS/2 and reboot for your network driver and
protocol(s) to take effect.
❒