User`s guide

6-4
Fast Ethernet Network Interface Cards
Configuring Ports
1
At the system command line type
pkgadd -d /tmp/EMPCI
2
After uncompressing the files the following message appears:
The following packages are available:
1 EMPCI
Type 1 to select EMPCI
Note:
Only one choice (1 EMPCI) is given here
regardless of how many NICs are installed.
3
Now a list of Adaptec NICs is displayed. Select the NIC you
wish to configure and press Enter.
Note:
For a multiport NIC there will be multiple
device listings. Each port must be configured.
4
Select the connection type and press Enter. For an explanation
of possible options see Connection Types on page A-2.
5
If prompted, select Half Duplex or Full Duplex and press
Enter.
6
The system will now automatically detect the next port. Repeat
Steps 4 - 5 for each port.
Configuring Protocols
1
At the system command line prompt type
/etc/confnet.d/configure -i
2
Select the NIC to configure and press Enter.
3
Follow the online prompts to configure the protocols.
4
Repeat Step 1 - 3 for each port.
5
Reboot the system.