User`s guide

2-8
Installing the Storage Enclosure
5 Slide the enclosure into the tower skin, as shown in Figure 2-6.
Figure 2-6 Sliding Storage Enclosure into Tower Skin
6 Replace the front bezel, using the screws removed in Step 3.
7 Install the tower labels at the top and bottom of the tower. Align
the holes in the top label with the LEDs on the enclosure.
8 Replace the drive carriers and APCs, if they were removed
before installation.
The tower assembly installation is complete. Continue with Step 3:
Installing the Drive Carriers on page 2-9.