User`s guide

2-4
Installing the Storage Enclosure
Installing into a Rack
Begin the installation by ensuring that you have all these rail kit
components:
■ Front rails (1 left, 1 right)
■ Rear rails, two different sizes (2 left, 2 right)
■ Two sizes of screws (10 large, 4 small)
■ Two types of nuts (10 of each)
To install your Storage Enclosure in a rack:
1 Secure the front rails to the front supports of the rack, using the
supplied screws, as shown in Figure 2-1.
Note: Use either the speednuts or cagenuts provided if
your rack does not have threaded holes.
Figure 2-1 Securing the Rails to the Rack
2 Check the length between the front and rear supports of your
equipment rack and determine which set of rear rails to use, the
long or the short.