User`s guide

Page | 4
This mode is used to perform a single, quick check of the array. After the verification process has
checked all sectors of the array, it stops and will not start again until started manually by the
administrator. In manual mode, the verification process commands are given a higher priority than in
Auto mode so that the check completes significantly faster.
Verify with fix is a data-level check and requires more controller resources to read and compare data.
Also, because of the additional resources required, verify with fix is not designed to run continuously.
Rather, it should be scheduled to run at a regular interval, preferably during periods of low drive activity,
or during system maintenance.
To verify and fix a logical drive using Adaptec Storage Manager:
a. In the Logical Devices View, right-click the logical drive.
b. Select Verify with fix and confirm that you want to verify
c. To begin the verification immediately, click Yes. To schedule the verification, click Schedule, and
then set the date and time. You can also choose to set the verification as a recurring task.
While the verification is in progress, the logical drive is shown as an animated icon to indicate that the
task is in progress.
When the verification is complete, an event notice is generated in the local system’s event log.
 Monitor Storage Manager Event Logs:
You can see status information and messages about the activity (or events) occurring on your storage
space by checking component properties and looking at the Event Viewer and status icons in Adaptec
Storage Manager. To open a full-screen version of the event log, click the Events button in the tool bar: