Specifications

VERIFY.NET FOR ADMINISTRATOR’S GUIDE
old Verify/LSIMSxp, the driver should already be installed and you can then skip to the Installation of
Temporary ID Page Settings section.
Follow the onscreen instructions to complete the driver installation. If given a menu to select a printer
model and port, ensure that the correct model and port is selected. If the printer has a USB connection,
do not plug the printer into the computer until the driver installation asks you to do so or until after the
installation is fully complete, including any computer restarts.
Driver Installation for Dymo LabelWriter 330 Turbo, 330, and 400 Turbo
1. Make sure the printer is NOT connected to the computer.
2. Download the driver from
http://www.omicrontech.net/Support/Verify.net/TempIDPrinter/LabelWriterDrivers-x86.msi
3. Follow the on-screen instructions to complete the driver installation wizard.
4. When asked by the wizard, select the type of printer (USB, Serial, Parallel).
5. When told to do so by the wizard, plug the printer into the computer.
6. Windows will detect the new printer and configure it. This may take a few minutes.
7. When the wizard is complete, ensure Windows recognizes the printer by going into the Control
Panel under Printers and Faxes.
8. If you do not see the new printer (e.g. Dymo LabelWriter 330), press the F5 key while still in the
Printers and Faxes folder to refresh the screen.
IMPORTANT: If you encounter any security permissions error messages (cannot access files) while
installing the driver, ensure the account you are logged in under Windows has the correct Windows-level
permissions. Make sure you are logged in as ‘techco’ or another Windows administrator account that has
sufficient permissions.
Installing Temporary ID Page Settings
Verify.NET requires that the page settings for the Temporary ID printer be defined at the Windows
driver level. To do this in Windows XP please complete the following:
1. Browse to the Control Panel.
2. If the Control Panel is in Category View, select Printers and Other Hardware and then open
Printers and Faxes. If it is in Classic View, select Printers and Faxes.
3. Rename the Temporary ID printer to ‘Verify.NET Temp ID Printer’.
4. Right click on the Temporary ID printer and click on Properties.
5. From this point, continue onto the section relevant to your printer model.
Page Settings for Dymo LabelWriter 330 Turbo, 330, and 400 Turbo
1. Click on the Advanced tab.
2. From the Advanced tab, click on the Printing Defaults button.
Page 20 of 27 OTI Proprietary and Confidential Rev. 2.0 – 8/20/2010