Specifications

VERIFY.NET FOR ADMINISTRATOR’S GUIDE
2. Double-click on the downloaded file.
3. Click Run, Allow, or Yes buttons for any security dialogs.
4. Follow the steps in the installation wizard to complete the setup.
5. Click Finish when prompted.
6. Plug the video capture device into your computer. Allow the computer to detect and activate the
device.
IMPORTANT: If you encounter any security permissions error messages (cannot access files) while
installing the driver, ensure the account you are logged in under Windows has the correct Windows-level
permissions. Make sure you are logged in as ‘techco’ or another Windows administrator account that has
sufficient permissions.
Checking For Video
You can confirm the video capture device is working properly by following the steps below:
1. Turn on computer and log onto Windows.
2. Plug the video capture device (e.g. Belkin)
3. Plug the camera in and turn it on. Make sure there is a live video feed in the camera viewfinder.
4. If possible, login to the old Verify application and ensure that the camera is working properly by
browsing to ID -> Student ID, searching for student, and clicking the Take Picture button.
5. Close out of the old Verify application.
6. Go to the Control Panel and open Scanners and Cameras
.
Page 15 of 27 OTI Proprietary and Confidential Rev. 2.0 – 8/20/2010