Product guide

Chapter Two System Features

Removing and Installing the SCSI

Cable, Teminator and Fan Module

For illustration purposes only, the Hard Drive Module is not shown connected to the

chassis. To remove or install a Hot Swappable Hard Drive Module 92mm Cooling

Fan:

1. To prevent damage to JP2 of the module, disconnect the fan power cable.

2. Release the Fan Retaining Tab (2) with the thumb.

3. Pull the fan out of the frame at a 45

angle until it clears the retaining tab.

4. Remove the fan from the frame.

5. The fan must be removed before the SCSI Cable connector can be

accessed.

6. To Install the fan, reverse the process. Do NOT force the fan into the

frame.

7. Ensure the SCA2 SCSI Cable, CON7 connector and Terminator, CON6

connector match pin-1 to pin-1.

Caution

To prevent damage to JP2 of the module,

disconnect the fan power cable.

The fan must be removed before the

SCSI Cable connector can be accessed.

Fan Retaining TabFan Power Cable

JP2

Fan Retaining Tabs

SCSI Cable

CON7

Terminator

CON6