Product guide

34
Chapter Two System Features
Removing and Installing a 5.25
inch Device
«
«
«
«
All 5.25-inch devices should be removed and installed using this process.
1 Completely remove the front bezel.
2. Remove the side panel from the chassis.
3 Disconnect all of the cable from the device.
4. Remove the retaining screws (1) that hold the device to the chassis. These
screws are not interchangeable with the slide rail retaining screws (2).
5. Pull the device out of the chassis (as shown in 1). It may be necessary to
push the device from the inside of the case.
6. Disconnect the slide rails bracket from the old device by removing the 3
mm screws (2) and attaching the slide rails to both sides of the new device.
Ensure the screws are tightened to at least 6 lb/ft., or hand tight.
7. To Install the new device, reverse the steps.
8. Insert the device until the slide rail bracket becomes flush with the chassis.
9. To prevent vibration, ensure the retaining screws secure the slide rail
bracket flush against the chassis’s edge. Ensure the screws are tightened
to at least 6 lb/ft., or hand tight.
10. Ensure the 5.25-inch device is connected to the correct power pins and
cables.
Warning
5.25 and 3.5-inch devices are NOT Hot
Swappable. Ensure AC Power is OFF
before Removing or Installing a 5.25
or 3.5-inch device.
«
1
1
2
2