Product guide

33
Chapter Two System Features
Installing the Side Panel
To replace the side panel, reverse the installation process. Be careful not to touch
the components with the panel.
1. Position the panel so the tabs align with the slots of the chassis.
2. Slide the panel toward the front or until it stops.
3. Tighten the retaining screws to secure the panel to the chassis.
Removing and Installing a
Cooling Fan
Each fan is held in its own retaining slot. Be careful not to break the retaining tab.
¬
¿
®
2
The fan should be installed to ensure air is exhausted from the chassis:
1 Remove the side panel from the chassis.
2 Release the retaining tab (2) with the thumb.
3 Pull the fan out of the base (as shown in 2) at a 45
0
angle until it clears all
of the retaining tabs.
4. To Install the cooling fan, reverse the steps.
5. Insert the fan at a 45
0
angle until it engages the rear retaining tabs.
6. To prevent vibration, ensure the retaining tab lip is secure against the fan’s
edge.
7. Ensure the fan is connected to the correct power pins and sensors.
8. Ensure the fan is positioned to vent the hot air out, and not force air and
dust into the system.
The retaining tab lip is
secure against the
fan’s edge.
¬