Product guide
108
Chapter Five Problem Solving
Hard Disk Drive Activity LED
Does Not Illuminate
If you have installed one or more hard disk drives in your system, check the
following:
q Are the power and signal cables to the drive properly installed?
q Are all relevant switches and jumpers on the hard drive and adapter board
set correctly?
q Is the onboard IDE controller enabled? (IDE hard drives only)
q Is the hard disk drive properly configured?
If the problem persists, there may be a problem with the Hard Disk drive, server
board or drive signal cable. Contact your Micronpc.com technical support
representative for help.
Front panel hard disk LED indicates IDE and SCSI devices: The hard disk drive
activity LED on the front panel illuminates when either an IDE hard disk drive or a
SCSI device, controlled by the onboard SCSI host controller, is in use. This LED
does not display CD-ROM activity.
Note
CD-ROM Drive Activity LED
Does Not Illuminate
Check the following:
q Are the power and signal cables to the CD-ROM drive properly installed?
q Are all relevant switches and jumpers on the drive set correctly?
q Is the drive properly configured?
q Is the onboard IDE controller enabled?
If the problem persists, there may be a problem with the CD-ROM Disk drive, server
board or drive signal cable. Contact your Micron technical support representative
for help.
Front panel hard disk LED indicates IDE and SCSI devices: The hard disk drive
activity LED on the front panel illuminates when either an IDE hard disk drive or a
SCSI device, controlled by the onboard SCSI host controller, is in use. This LED
does not display CD-ROM activity.
Note