Product guide

100
Chapter Four Configuration Software and Utilities
Running the Firmware Update
Utility (continued)
6. The utility will ask for a file name. Enter the name of the *.hex file.
7. The program will load the file and then ask if it should “Upload Boot Block.”
Press “N” to continue.
8. The program will next ask if it should “Upload Operational Code.” Press “Y”
to continue.
9. Once the operational code has been updated and verified, press any key to
continue. Then press the ESC key to exit the program.
10. Shut the system down and remove any floppy disks that may be in the
system.
11. Disconnect the AC power cord from the system and wait 60 seconds.
12. Connect the AC power cord and power up the system.
Installing Video Drivers
After configuring the system, you need to install video drivers to take full advantage
of the features of the onboard Cirrus Logic CL-GD5480 super VGA video controller.
q The Micron Computer Resource CD includes video drivers for use with DOS
and Windows NT. Check the README.TXT file on the CD for information
on installing these drivers.
q For other operating systems, see your OS instructions for installing device
drivers.
Using the Adaptec SCSI Utility
The Adaptec SCSI utility detects the SCSI host adapters on the server board. The
utility runs out of BIOS and is used to
q Change default values
q Check and/or change SCSI device settings that may conflict with those of
other devices in the server
Running the SCSI Utility
1. When this message is displayed on the monitor:
Press Ctrl-A to run SCSI Utility...
2. Press <Ctrl+A> to run this utility. When the SCSI Utility screen appears,
choose the host adapter that you want to configure.
Another Adaptec utility that is available on the Micron Computer Resource CD is the
Adaptec EZ SCSI utility. It is designed to be installed from the CD directly to a
DOS or Windows operating system.