Instruction manual

D-5
Using a CD-ROM Drive
Using a CD-ROM Drive with NetWare
To operate a CD-ROM drive connected to the ARO-1130SA under
NetWare, you need the
aspicd.dsk driver. The driver must be copied
from the \dos directory on the Array1000xA Family Manager Set
driver diskette to a directory on your hard disk drive.
Follow these steps to set up the CD-ROM drive under NetWare:
1
At the server prompt, enter
load install
2
From the Installation Options menu, select Available System
Options and then Edit STARTUP.NCF.
3
Insert the following lines:
load [pathname] aspicd.dsk
load cdrom.nlm
4
Press the Esc key, save the changes, and exit install.nlm .
5
Down the server normally and restart.
Note:
To access your CD-ROM without restarting your
server, simply enter each of the command lines listed in
Step 3 at the server prompt (:); then proceed to Step 6.
6
At the server prompt, enter
cd device list
A list of CD-ROM drives appears.
7
Write down the device number and volume name of the
CD-ROM.
8
At the server prompt, enter
cd mount < x > < name >
where <x> is the device number and <name> is the volume
name you wrote down in step 5.
❒