Instruction manual

A-1
A
▼ ▼ ▼ ▼
Configuring ARO-1130SA
with the SCSISelect Utility
The SCSI
Select
configuration utility allows you to change SCSI set-
tings without opening the server chassis or handling the card.
SCSI
Select
also contains utilities that allow you to low-level format
or verify the disk media of your SCSI hard disk drives.
The SCSI
Select
settings are listed in the table below. If you want to
view and/or change the current settings, or if you would like to for-
mat or verify a disk, see
Starting the SCSISelect Utility
on page A-2.
Detailed descriptions of each setting begin on page A-4.
SCSI Bus Interface Definitions
Host Adapter SCSI ID
SCSI Parity Checking
Host Adapter SCSI Termination
Host Adapter Ultra
SCSI
SCSI Device Configuration
Initiate Sync Negotiation
Maximum Transfer Rate
Enable Disconnection
Initiate Wide Negotiation
1
1
This option is available only if Wide SCSI is sup-
ported on the motherboard.
Send Start Unit Command
Include in BIOS Scan
Additional Options
Array1000xA BIOS
BIOS Support for Bootable CD-ROM