Instruction manual

6-2

ARO-1130SA Installation and Hardware Guide

Installing the Array1000SA Driver for Novell

NetWare

This section explains how to install the Adaptec Array1000SA driver

(

cda1000.dsk

) for NetWare. To begin driver installation, see either

Installing the Driver When Installing NetWare below, or Installing the

Driver When NetWare is Already Installed on page 6-5.

Note:

We recommend that you install your Novell NetWare

operating system on an array to take advantage of the

redundancy and performance features of the array.

Note:

If your system: 1.) is RAIDport I or II equipped; AND

2.) has an Adaptec AHA-294x, AHA-3940, or any other

AIC-78x0 based host adapter installed; AND 3.) requires

driver Disk B (as determined by the Array1000xA BIOS &

Driver Selection Utility), see Appendix B, Using the

ARO-1130SA with Other Adaptec Products.

Installing the Driver When Installing NetWare

To install the

cda1000.dsk

driver when you are installing NetWare,

follow the instructions below for the version of NetWare you are

installing.

NetWare 4.11

Follow these instructions only if you are installing NetWare 4.11 for

the first time:

Follow the procedures in your NetWare documentation for

installing a new server. (For information on using a CD-ROM

drive on a NetWare server, see Appendix D, Using a CD-ROM

Drive in this installation guide.)

When a screen appears that asks you to select a disk driver,

press Enter.

Press Insert to install an unlisted driver.