Instruction manual

6-1

▼ ▼ ▼ ▼

Installing Software on a

Novell NetWare Server

This chapter explains how to install the software required to use the

ARO-1130SA in a Novell NetWare (NetWare 3.12 and 4.11) server.

Before installing the software, make sure the ARO-1130SA is already

installed. If you have not already done so, run the Array1000xA BIOS

& Driver Selection Utility (see Chapter 3) to determine which of the

two Manager Set driver diskettes (Disk A or Disk B) is required to

install the NetWare driver.If you plan to boot from an array, make

sure the array is already created. To install all of the software, you

must complete the following in the order presented:

■

Install the

cda1000.dsk

driver for Novell NetWare

■

Install the TIRPC Communications Module

■

Install the Adaptec CI/O Management Software for Novell

NetWare

Once all software is installed, refer to the

Adaptec CI/O Management

Software User’s Guide

for instructions on adding, deleting, and man-

aging your arrays from the server console.

Note:

If your RAID

port

I or II system has an additional

Adaptec AHA-2940, AHA-3940, or any other AIC-78x0

based host adapter installed, the NetWare driver for these

adapters must be from the Adaptec 7800 Family Manager

Set 1.3 or later. Furthermore, if the Array1000xA BIOS &

Driver Selection Utility determines you require Disk B, refer

to Appendix B.