Instruction manual

5-5
Installing Software on a Windows NT Server
Installing Adaptec CI/O Management Software
for Windows NT Server
Note:
The Adaptec CI/O Management Software installation
process automatically installs both CI/O server and client
components on your Windows NT Server. Before you start
the Adaptec CI/O Management Software, be sure that com-
munication with the server via the network is already estab-
lished. (See the documentation provided with your TCP/IP
software for instructions on establishing communications,
and also Hints for Establishing Communications With Your
Server on page 7-3.)
Follow these steps to install the Adaptec CI/O Management Soft-
ware for Windows NT:
1
Start Windows NT.
2
Insert the Adaptec CI/O Management Software CD-ROM in
your CD-ROM drive. If you are installing the software from
diskettes, insert Disk 1 of the Adaptec CI/O Management Soft-
ware for Windows NT Server in the floppy disk drive.
3
Select Run from the File menu (Windows NT 4.0 users select
Start, and then Run), type the following and press Enter:
[pathname] setup.exe
(The setup.exe file is located at \win_nt\disk1\setup.exe on the
CD-ROM, and at
\setup.exe on Disk 1 of the Adaptec CI/O
Management Software for Windows NT Server.)
4
Follow the directions that appear on the screen.
5
When installation is complete, reboot the system. The follow-
ing NT Services start automatically in the background:
CIO Array Management Service
CIOArrayManager RPC Command
CIOArrayManager RPC EventP
CIOArrayManager RPC Event
NobleNet Portmapper