Instruction manual

5-4
ARO-1130SA Installation and Hardware Guide
Installing the Driver When Windows NT is Already Installed
To update or install the cda1000.sys driver if Windows NT is
already installed, follow these steps:
1
Start Windows NT.
2
Click the Start button on the Windows NT task bar, and then
point to Settings.
3
Click the Control Panel.
4
Double-click the SCSI Adapters icon.
5
Click the Drivers tab, and then click the Add button.
6
In the Install Driver window, click the Have Disk button.
7
Insert the Appropriate Adaptec Array1000xA Family Man-
ager Set driver diskette (Disk A or Disk B) in your floppy
disk drive and press Enter; (See Running the Array1000xA
BIOS & Driver Selection Utility on page 3-2 to determine the
appropriate driver diskette.) Enter the following path to the
installation files and then click OK.
a:\winnt
The Adaptec Array1000xA Family Adapter driver is high-
lighted by default.
8
In the Install Driver window, Click OK.
9
Click the New button when asked if you want to use the cur-
rently installed driver(s) or install new one(s).
10
Type a:\winnt again, and click Continue. The driver is now
installed.
11
You must restart your computer for the changes to take effect.
Click Yes to restart your computer.