Instruction manual

5-1

▼ ▼ ▼ ▼

Installing Software on a

Windows NT Server

This chapter explains how to install the software required to use the

ARO-1130SA in a system using Windows NT 4.0 Server.

Before installing the software, make sure the ARO-1130SA is already

installed. If you have not already done so, run the Array1000xA

BIOS & Driver Selection Utility (see Chapter 3) to determine which

of the two Manager Set driver diskettes (Disk A or Disk B) is

required to install the Window NT driver. If you plan to boot from

an array, make sure the array is already created. To install all of the

software, you must complete the following in the order presented:

■

Install the

cda1000.sys

driver for Windows NT

■

Install the Adaptec CI/O Management Software for Windows

Once all software is installed, refer to the

Adaptec CI/O Management

Software User’s Guide

for instructions on adding, deleting, and man-

aging your arrays.

Note:

If your RAID

port

I or II system has an additional

Adaptec AHA

-2940, AHA-3940, or any other AIC

™

-78x0

based host adapter installed (which is not associated with

the RAID

port

), the driver for these adapters must be from

the Adaptec 7800 Family Manager Set 1.3 or later. Further-

more, if the Array1000xA BIOS & Driver Selection Utility

determines you require Disk B, refer to Appendix B.