Instruction manual

3-2
ARO-1130SA Installation and Hardware Guide
Running the Array1000xA BIOS & Driver
Selection Utility
The Array1000xA BIOS & Driver Selection Utility is provided on a
bootable floppy disk and runs under DOS as a stand-alone utility. A
simple-to-use interface prompts you through the process. Follow
these steps to run the Array1000xA BIOS & Driver Selection Utility:
1
Insert the Array1000xA BIOS & Driver Selection Utility dis-
kette in drive A and reboot your server. The utility starts
automatically and the initial Array1000xA BIOS & Driver
Selection Utility screen appears.
Note:
The initial Array1000xA BIOS & Driver Selection
Utility screen identifies which of the two Manager Set
driver diskettes (Disk A or Disk B) are required when
you install the operating system driver, as explained in
Chapter 5 and Chapter 6. Make a note of which diskette
to use, and continue with Step 2.
2
Select either Express or Advanced setup.
Note:
If you receive an “Unsupported Hardware Con-
figuration,” message during setup, contact the system
manufacturer. The ARO-1130SA is not supported by
the system.
■
Express setup automatically updates the ARO-1130SA
BIOS. Select Express setup and the utility will do the rest.
When prompted, remove the floppy disk and press any key
to reboot the server. Continue with the Step 6.
■
Advanced setup also allows you to update the
ARO-1130SA BIOS. In addition, Advanced setup allows
you to select other options such as:
– Display Current BIOS Checksum. Determines current
version of the ARO-1130SA BIOS.
– Display New BIOS Checksum. Determines version of
the BIOS available on the floppy.